**Make:** CMI
**Type:** Portable
The Model of this unit is : SE65 3SW
The Serial Number is: 114
**Additional Information:**
* Surge bin
* Reverse weigh
* Split discharge
* 300-350 TPH slat conveyor, 60'
* Double chain, 36" box with 32" slats
* Reject chute
* 75 HP motor and reducer
* Cable erection with pack and gas motor
* 100-gallon air tank
* Tandem axle (tires appear to be in good condition with mud flaps and lights; per owner, the silo is road-ready)
* Wired with quick disconnect
**Note**: This silo was in use earlier this year and had no major issues at shutdown. ASI recommends that road-readiness be verified prior to purchase.
**Make:** CMI (Caterpillar)
**Model:** SE652
**Serial Number:** SE652-116
**PIN:** X5AD00056X
**Arrangement Number:** 8TC101
**Additional Information:**
* 65-ton surge bin
* Reverse weigh
* Split discharge
* Approx. 250-300 TPH slat conveyor
* Approx. 19" slats, double chain
* Reject chute
* 50 HP motor and reducer
* Tandem axle (tires appear to be in good condition with mud flaps and lights)
* Wired with quick disconnect
* **Note:** Control panel shown in photos is no longer available on this unit.
## On ground, ready for loadout
Used CAT Model SE653; 65 Ton Self-Erect Silo S/N SE653-139
65 Ton Bin, Air Gate,
Reverse Weigh Load Cells
Slat Conveyor,
Drive Motor, New floor installed and operated only 1 season
3 Axle Carrier
All New radial Tires installed in 2018
Astec self-erect silo system
This portable astec self-erect silo system is in nice condition.
• two bin storage both bins are on independent weigh scales
• main bin 65 ton
• secondary bin 30 ton
• the drag slat conveyor is 300+ tph.
• this unit will need new chain and the sprockets moved
• "the chain "single 4” pitch roller chain uses 21” x 6” x ¾” slats" was shortened and sprockets moved to accommodate a jumper slat "
• the unit has a ni-hard floor with side wear protection.
• sliding bearings on the side walls help insure long chain life.
• a 50 hp motor provides the power (not on unit)
• the batcher is mounted on the end of the drag conveyor.
• second hopper is fed through the reject chute
• heavy abrasion resistant steel liners are in the cone area.
• an air compressor is mounted tank is mounted on the side
• electrical is mounted in a side nema cabinet.
• the suspension is quad axle
• the system is cable erected
Make: CAT
Year: 1986
Model: SE-653
S/N: 152
Capacity: 65ton
. 65 Ton Surge Bin w/ Reverse Weigh
. 500 TPH Slat Conveyor w/ 36” Slats; Double Chain
. Reject Chute
. 75 HP Motor w/ Gear Reducer
. Air Compressor w/ Tank
. Cable Erect w/ Power Pack
. Tandem Axle
(Tired appear to be in good condition, with mud flaps and lights)
. Wire with Quick disconnect
. On ground and ready to load
Make: Barber Greene
Portable
50 Ton
This Portable Self Erecting Barber Greene Bin and Bucket Elevator is located in Northern Minnesota. It is used occasionally as a spare. Load Cells. **The speed reducer MAY not be available upon purchase.**